Audio-Technica
ATH-TWX9MK3
Audio-Technica launches ATH-TWX9MK3 flagship earbuds in Japan
The ATH-TWX9MK3 succeeds the ATH-TWX9MK2 in Audio-Technica’s true wireless range. Each earbud pairs a beryllium-coated driver with noise cancellation that adapts as the fit changes.
Georg S. Kuklick
•

Audio-Technica released its flagship true wireless earbuds in Japan on 20 November 2026. The ATH-TWX9MK3 supports Bluetooth audio at up to 24-bit/192 kHz via LHDC-V5 when the source device also supports that rate. The Japanese launch price was approximately ¥41,800 including tax.
Rated playback with LHDC-V5 is up to six hours per charge with active noise cancellation (ANC) on or off. LDAC supports up to 24-bit/96 kHz, with rated playback of up to seven hours with ANC on or nine hours with it off. With AAC or SBC, those figures rise to 11 and 15 hours respectively. A 15-minute charge provides approximately 90 minutes of AAC playback with ANC on, and the case supports Qi wireless charging.
Each earbud uses a 5.8 mm dynamic Pure Motion Driver Gen2. A thin stainless-steel ring secures the edge of its beryllium-coated composite diaphragm. The driver retains an external magnetic circuit, and the voice-coil wiring hangs clear of the diaphragm to reduce the load on it. Sefar acoustic mesh regulates airflow behind the driver.
Fit-Adaptive ANC uses feedforward and feedback microphones to adjust its filters in real time as the fit of each earbud changes. The Connect app offers Transit, Outdoor and Indoor presets, along with ten levels of ambient sound in hear-through mode. For calls, two microphones in each earbud provide directional pickup, while a deep neural network separates speech from background noise.
The earbuds use Bluetooth 6.0. With LE Audio switched off, multipoint allows the earbuds to stay connected to two devices at once. Audio-Technica plans to add LE Audio features, including Auracast reception, through a phased firmware rollout.
Key specifications
Driver | 5.8 mm dynamic Pure Motion Driver Gen2 with beryllium-coated diaphragm |
|---|---|
Earbud frequency response | 10–40,000 Hz |
Output sound pressure level | 107 dB/mW |
Impedance | 16 Ω |
ANC | Fit-Adaptive; Transit, Outdoor and Indoor presets |
Microphone elements | Omnidirectional MEMS |
Microphone sensitivity | −38 dB (1 V/Pa at 1 kHz) |
Microphone frequency response | 20–10,000 Hz |
Bluetooth version | 6.0 |
Bluetooth range | Up to 10 m with clear line of sight |
Radio band | 2.402–2.480 GHz |
Radio modulation | GFSK, π/4-DQPSK, 8DPSK; FHSS spread spectrum |
Sources
Data Source