Qln
Prestige One Gen 2
Qln updates its Prestige One monitor with a dual-layer cabinet
The Prestige One Gen 2 adopts the small, sloping baffle used on Qln’s Prestige Three and Prestige Five. The second-generation monitor also has a new first-order crossover and revised internal wiring.
Georg S. Kuklick
•

Well Pleased Audio Vida has introduced the successor to Qln’s Prestige One loudspeaker. The Qln Prestige One Gen 2 is a compact two-way monitor with a redesigned cabinet made from dual-layer Qboard.
The top of the cabinet takes the form of a truncated pyramid to minimise the area of the front baffle. As on the Prestige Three and Prestige Five, the baffle slopes back to align the drivers in time, compensating for the tweeter’s acoustic centre sitting farther forward than the woofer’s. The bass-reflex port flares at both ends. Inside the cabinet, a blend of wool and a small amount of synthetic fibre provides acoustic damping.
Scan Speak developed the coated Kevlar mid-woofer, which incorporates a copper ring in its magnet system. The 25 mm textile-dome tweeter has a large roll surround and uses an AirCirc magnet system with a rear chamber. Its frequency response extends above 30 kHz.
The redesigned crossover uses a hardwired first-order 6 dB filter. Qln uses polypropylene capacitors throughout the network, with oil-filled units in the tweeter section. All the coils have air cores, and those in the woofer section have lower losses than in the previous design. Damping glue holds the components in place, and the coils are baked to limit resonance.
The revised internal cable is made in Sweden and uses solid copper conductors with Teflon insulation inside an acoustic damping shield. The speaker terminals are pure-copper WBT Nextgen connectors.
Key specifications
Configuration | Two-way bass-reflex monitor |
|---|---|
Cabinet construction | Dual-layer Qboard; truncated-pyramid top; slanted baffle |
Reflex port | Trumpet-shaped flare at both ends |
Acoustic damping | Wool with a small amount of synthetic fibre |
Mid-woofer | Custom Scan Speak coated Kevlar driver; copper ring in magnet system |
Tweeter | 25 mm textile dome; large roll surround; AirCirc magnet system with rear chamber |
Tweeter response extension | Above 30 kHz (driver only) |
Crossover | Hardwired first-order 6 dB design |
Crossover components | Polypropylene capacitors, oil-filled in the tweeter section; air-core coils |
Internal cable | Solid copper cores, Teflon insulation and acoustic damping shield |
Speaker terminals | WBT Nextgen pure copper |
Sources
Data Source